Hey Guys,
Introduction
Mr. Veera Sundar completed Manual programming and NX CAD CAM training from Millwright CNC CAD CAM Hosur,
He was working in an operator position and was looking to get to the next level in his career. He decided to...
Hello all,
In addition to the number of Satisfied students, here is yet another student who has completed Mastercam training and gave us valuable feedback.
Introduction
Mr. R Kannan is basically from Thanjavur and knows the basics of CNC manual 2D programming...
Hi guys,
Introduction
In this blog, you will see the feedback of Mr Ajay who recently completed CNC manual programming training from Millwright CNC CAD CAM training center.
He was basically an electronic student but had the strong will and intentions to...
Hi CNCist,
In this blog, Mr Abubakker Siddique completed Mastercam training from Millwright CNC CAD CAM training center.
Introduction...
Mr Abubakker is basically from Maduravoyl Chennai, he was working in a company in Vanagaram.
Finding out about Millwright...
He was searching for the Best...
To begin with,
Introduction...
Mr. Shanmugapriyan recently completed CNC manual programming and Mastercam. He is basically from Perumbulur district and was looking to get good CNC CAD CAM training.
His friends suggested he go to Millwright for his CNC CAD CAM programming...
CIMATRON training in Chennai
Millwright Technologies is pleased to say that we are implementing CIMATRON in our training program.
About Millwright...
Millwright Technologies is been training students for the last 14 years, with an experienced set of engineers who are also experts...
Hi guys !!!
In this post, we will get to know the feedback of Mr. Rajkumar.
At first,
Introduction...
Mr. Rajkumar is from Trichy and works in a company in Ambattur as a CNC operator. He wanted to reach to the next level...
Hello guys,
Mr. Balamurugan completed Mastercam training, from Millwright CNC CAD CAM training center. Gave his honest and Candid feedback on his training experience from Millwright CNC CAD CAM training center.
Intro...
He was first working as an operator for several years...
Hello CNC knowledge seekers,
Introduction
Firstly,
In this post, you see the honest and candid feedback of Mr. Vetri who completed Mastercam training from MIllwright CNC CAD CAM training center.
He also shared his experience while getting trained, and he also explained some...
In this tech blog, we would like to explain how to store work offset value in an NC program, in other words, we can say, how to use G10 (Programmable Data input) command in fanuc. While writing CNC programming
G10...
